Wild Boss
(600-4141)                 Operation                  Faxback Doc. # 18393

Driving the Wild Boss

WARNING:  Never play with your Wild Boss in the street.

CAUTIONS:  Do not use the Wild Boss on a wet floor, on sand, or in mud,
           rain, or snow.  These can damage it.

           If the Wild Boss moves slowly, and you have installed fresh
           batteries, check the wheel mechanisms and remove any lint,
           thread, hair, or dust you find.

Follow these steps to drive the Wild Boss.

1.  Set ON/OFF on the back of the Wild Boss to ON.

2.  Press and hold down UP ARROW to move forward.  Press and hold down
    DOWN ARROW to circle backward.  Release UP ARROW and DOWN ARROW to
    stop.

3.  When you finish driving the Wild Boss, set ON/OFF to OFF.

Wheel Alignment

If the Wild Boss does not go straight when you press and hold down adjust
the wheel alignment control on the bottom of the Wild Boss.

Use a coin to turn the wheel alignment control toward the left if the Wild
Boss is pulling to the right, or toward the right if the Wild Boss is
pulling to the left.

Helpful Hints

These hints can help you get the most enjoyment from your Wild Boss.

    For maximum battery life, turn the Wild Boss off for 45 minutes after
    every 15 minutes of continuous use.

    If the Wild Boss moves slowly or not at all, replace the Wild Boss's
    batteries.

    If the Wild Boss' motor runs but the Wild Boss does not respond to the
    transmitter, move closer to the Wild Boss and try again.  If the Wild
    Boss' motor still does not respond, replace the transmitter's 9-volt
    battery.

    If someone uses a CB nearby, it might interfere with control of the
    Wild Boss.  If this happens, move the Wild Boss away from the CB.

    You cannot operate your Wild Boss near devices with transmitters which
    use the same frequency.


(PH 11/8/95)