Mini Strobe/Flasher
(420-3048)                 Installation               Faxback Doc. # 34023

You can mount the Mini Strobe/Flasher on a desk or tabletop, or on a wall.

Choose a location for the Mini Strobe/Flasher that is:

     Out of the way or normal activities.

     Sturdy enough for wall mounting.

     Near an AC outlet.

DESK MOUNTING

You can place the Strobe/Flasher on a desk, tabletop, or any other flat
surface.

WALL MOUNTING

1.  Using the mounting bracket as a template, mark the locations for the
    mounting screws.

2.  Drill two holes, 1/8 inch in diameter, at the marked locations.

3.  Using a Phillips screwdriver and the supplied screws, attach the
    mounting bracket to the selected location.  Make sure the mounting
    bracket is attached securely.

4. Mount the Strobe/Flasher on the mounting bracket using the supplied
    screws (with knobs) and washers.  Raise or lower the front end of the
    Strobe/Flasher to the desired angle, then tighten the screw on each
    side.

CONNECTING POWER

Connect the AC cord's plug to a standard AC outlet.  The light begins to
flash as soon as you connect the Strobe/Flasher to AC power (unless the
flash rate control knob is set fully counterclockwise).

CAUTION:  The AC plug has a third pin and only fits into a grounding-type
          power outlet.  If you are unable to insert the plug into the AC
          outlet, do not defeat the purpose of the grounding-type plug.


(YO/EB 6-19-96)