LCD Digital Multimeter
(220-0185A)             Controls and Functions         Faxback Doc. # 16936

1.  Digital display:

    a.  Low BATTery indicator     - lights when batteries are weak and
                                    need replacing.

    b.  AC indicator              - lights when you select the AC
                                    voltage/current measurement.

    c.  Measured input values     - shows the measured value with
                                    decimal point and minus polarity
                                    indication (2999 maximum).

    d.  Measuring unit indicators - lights to show the current measuring
                                    unit.

    e.  Diode check indicator     - lights in the diode check mode.

    f.  Continuity indicator      - lights during the CONTINUITY check
                                    mode.

2.  Power switch:     Turns the meter ON and OFF.  Set to CONTINUITY
                      for continuity check.

3.  Range switch:     Used for selecting ranges:
         Voltage:     DC V  300mV, 3V, 30V, 300V, 3000V
                      (Maximum measurable voltage is 1000V).

                      AC V  3V, 30V, 300V, 3000V 
                      (Maximum measurable voltage is 750V).

         Current:     3mA, 30mA, 300mA, 10A

      Resistance:     300ohm, 3kohm, 30kohm, 300kohm, 3000kohm, 
                      30 Mohm
      Diode Check

4.  Function switch:  Used for selecting functions: DC V, AC V, Diode
                      CHECK, kohm, DCmA and ACmA.

5.  Input (10A) jack: Connect (+) red lead for current measurement
                      with the 10A setting of the range switch.

6.  Input (-) jack:   Connect (-) black lead for all measurements.

7.  Input (+) jack:   Connect (+) red lead here for all measurements
                      except 10A range.

8.  Battery/fuse
    Compartment:      Open to install/replace fuse and/or batteries.

9.  Fold-out Stand:   Use to support the multimeter at a convenient
                      viewing angle for benchtop use or to hang it
                      up.

Special Panel Markings

(A)  AC/DC            Special markings has been added to the panel
     AMPS             to remind you of the measurement limitations
     ONLY             and safety.
     
     10A MAX          The maximum current that can be measured is
     UNFUSED          DC/AC 10A.  10A range is not fuse-protected.

(B)  750V             To avoid electrical shock and/or instrument
     MAX              damage, do not connect the common input
     GROUND Symbol    terminal (-jack) to any source of more than
                      750V with respect to earth/ground.

(C)  EXCLAMATION
     Symbol           Refer to complete operating instructions.

(D)  1000V DC         The maximum voltage that can be measured is
     750V AC          1000V DC or 750V AC.  The maximum current
     300mA            measurement at this terminal is 300mA.
     MAX

(E)  LIGHTING BOLT    Be extra careful when making measurements for
     Symbol           high voltage;  DO NOT TOUCH TERMINALS OR PROBE
                      ENDS.