ProbeScope V3.0 for Windows/DOS
(220-0310)                 Specifications             Faxback Doc. # 33359


Sampling Rates:................................................. 50, 100 ns
                                                        .5, 1, 5, 10, 50 us
                                                               .1, .5, 1 ms
DC Band Width:.................................................. DC - 5 MHz
AC Band Width:.............................................. 100 Hz - 5 MHz
A/D Converter:............................................ 6-Bit resolution
RAM:............................................................. 128 Bytes
Input Coupling:....................................... AC, DC, GND (Ground)
Input Voltage Rates:....................................... 1 V, 10V, 100 V

NOTE:  All voltage measurements are referenced to 0V ground.  The effective
       ranges for AC volt measurements in DVM mode are 0.33V, 3.3V and 33V
       since the peak-to-peak voltage must be digitized and converted to
       the RMS value.

Trigger Definitions:.............................. Auto, External, Internal
Trigger Levels:...................................... Six selectable levels

NOTE:  Levels tolerances are dependent on the selected input voltage range:
       1V +/- 1V, 10V +/- 3V, 100V +/- 10V

Trigger Modes:................................. Continuous RUN/SINGLE Cycle
Display:.......................... 16 x 32 dots resolution, LED backlighted
Serial Line:.................................................. 19,200 kBaud
                                         7 Data Bits, 1 Stop Bit, No Parity
DVM Accuracy:.............................................. +/- 2 to +/- 5%
                                      (depending on the parameter settings)
Power Supply:................................................... 9 - 13V DC
                                      red (+) and black (-) alligator clips
Current Required:............................. Backlight Off = 12mA Typical
                                                Backlight On = 85mA Typical
Dimension (HWD):................................... 6 1/2 x 1 5/18 x 3/4 in
                                                         (165 x 33 x 19 mm)
Weight:........................................ About 1 lb, 14.4 oz. (86 g)

Specifications are typical; individual units might vary.  Specifications
are subject to change and improvement without notice.


(yo/all-06/13/96)