2-Station Wireless  (430-0486)     Installation       Faxback Doc. # 14124
Intercom

SELECTING A LOCATION

The intercom consists of two stations.  You can install the stations
almost anywhere there is a standard AC outlet.  You can place each station
on a desktop or table or mount it on a wall.

Notes:  Stations can transmit up to 300 feet and between building, as long
        as they are connected to the same power line transformer.  Most
        residential and many commercial properties meet this requirement.

        Placing the stations too close together (for example, in the same
        room) creates feedback, which produces a squealing sound.

CONNECTING TO POWER

Simply plug each station's power cord into an outlet and you are ready to
communicate.

MOUNTING A STATION ON A WALL

To mount a station on the wall, you need two screws (not included) with
heads that fit into the station's keyhole slots.

Follow these steps to mount a station on the wall.

1.  On the mounting surface, mark two dots (one above the other) 2 3/4
    inches apart.

2.  Drill pilot holes on each mark.

3.  Thread the screws into the holes until the heads extend about 1/8 inch
    from the wall.

4.  Place the station's keyhole slots over the screw heads and gently pull
    down the station to secure it.

USING ADDITIONAL STATIONS

You can add additional stations to the intercom.  Any Radio Shack wireless
intercom that transmits on the same frequency (200 kHz) is compatible.
If you want to set up a separate intercom system, be sure it operates on a
different frequency.

(LB/all-03/13/95)