Ericson (170-1064) Dual-NAM Programming Faxback Doc. # 14493 Short NAM-programming mode: Press and hold down FCN while entering the digits 987. You must enter the digits within ten seconds. The text "SER NUMBER" is displayed along with the telephone's electronic serial number. The number contains 11 digits, so the most significant digit is shown for one second, followed by the other 10 digits. ENTRY DISPLAY TEXT PERMISSIBLE VALUE Electronic Serial # ESN Not changeable Phone Number MIN x (x is NAM #) 10 digits System ID SID x (x is NAM #) 00000 to 32767 Press "#" or "*" to review MIN & SID, or END/PWR to exit the short NAM-programming mode. Long NAM-programming mode: This should be used only to troubleshoot NAM problems. When in doubt, use the "Short" NAM-programming above. Press and hold down FCN while entering the digits 923885. You must enter the digits within ten seconds. Note: "x" is the NAM #. ENTRY DISPLAY TEXT PERMISSIBLE Electronic Serial # ESN Not Changeable Emergency Number EMERGENCY? 3 - 10 digits Phone Number MIN x ? (x is NAM #) 10 digits Phone Number SUB NO X ? 10 digits System I.D. SID x 00000 to 32767 MIN MARK MARK x OFF ON/OFF Paging Channel IPCH x ? 333 or 334 Overload Class ACCOLC x ? 00 to 15 Group I.D. Mark GIM x ? 00 to 15 Press # to step through and review your choices for NAMs 1 and 2, then press END/PWR to exit NAM-programming when you are finished. In some steps, you can "toggle" a setting from ON to OFF, or vice versa. To change the setting, press any digit key. Menu functions: 1. Press then 2. Press "#" for forward, "*" for backward through functions. 3. Press any digit key (1-9) to select an option within a function. 4. Press to store desired option. 5. Press to exit menu. Menu Pos. Function Menu Pos. Function 1. Telephone # Selection 2. Electronic Lock/Call 3. Ring Volume 4. Ring Tone 5. System Selection 6. LCD Contrast 7. Answering Methods 8. Key Burst, Tones, Clicks 9. Microphone Volume 10. Auto Retry on System Busy 11. Backlight Selector 12. Unanswered Call Counter 13. Auto Area Code 14. Voice Operated Transmission 15. Bat. Voltage 16. Total Accumulated Time 17. Resettable Call Timers 18. Last Call Time 19. Keypad Lock For Example: To change the "System Selection": Press then "#" 4 times. then push the "1" key until the option you want is displayed (like "Pref Sys"); press to store the setting, then to exit the menu mode. (PN/jlc-03/29/96)