ET-142 Two Line Telephone with Auto-Dialer (430-0640) Specifications Faxback Doc. # 14892 Pulse Dialing Rate: ............................................... 10 pps Make/Break Ratio: .................................................. 40:60 Inter-Digit Pause: ................................................ 800 ms Redial Memory Capacity: ................... Up to 32 digits in pulse mode; up to 31 digits in touch-tone mode Touch-Tone Dialing: ........................................ Standard DTMF Telephone Connector: ................................... Modular Connector (USOC type RJ-14) Access Pause: .......................................... Approx. 2 seconds Memory Capacity: ................................ 16 digits in pulse mode; 15 digits in tone mode Memory Positions: .................................. 21 (including redial) Accessory: ................................ Telephone cord with RJ-14 plug Dimensions: ..................................... 4-1/4" x 6-3/8" x 8-7/8" (109mm x 163mm x 225mm) Weight: ............................................... 1 lbs 15 oz (885g) Operating Parameters This information is supplied to help you answer possible technical questions from your phone company. Interface: .................................................... Loop Start Ringer: .......................................... Standard Bridged Ringer 20-60 Hz Sine or Square Wave 40-105 Volts Ring Signal Current: .................................... 6-15 VDC (Off Hook) 20-70 mA Resistance: ........................ 10 M Ohm (on Hook)/300 Ohm (Off Hook) NOTE: This phone has continuous DTMF / key following. Specifications are typical; individual units might vary. Specifications are subject to change without notice. (LB/EB 09/03/96)