Caller ID Blocker
(430-0925)                  Operation                 Faxback Doc. # 17963

Installation and Use

1.  Unplug telephone modular plug.

2.  Insert modular cord from wall into either jack on this unit.

3.  Plug cord with modular connectors from other jack on this unit to the
    telephone.

This unit should then block your number from being displayed when any
telephone on that line is used.  If you have Call Notes, it will block the
tones that Call Notes sends to you to indicate you have messages.  You
will have to wait until this unit sends its tones, then press Flash or
switchhook and then dial your access number and password to check your
calls.


Use with Modem

Install the same way as with a telephone.
1.  Plug the supplied line cord into either end of ID Blocker.
2.  Unplug phone cord from wall jack.
3.  Plug the free end of the ID Blocker into the wall jack.
4.  Plug the phone cord into the ID Blocker.


(IR/ir-03/05/96)