TAD-1004
(430-0744)                 Preparation                Faxback Doc. # 18954

SETTING THE PULSE/TONE SWITCH

Set PULSE/TONE for the type of service you have.  If you are not sure which
type you have, follow these steps.

1.  Set PULSE/TONE on the back of the TAD to TONE. 

2.  Lift the handset and listen for a dial tone. 

3.  Press any number other than 0. 

If the dial tone stops, you have touch-tone service.  Leave PULSE/TONE set
to TONE.

If the dial tone continues, you have pulse service.  Set PULSE/TONE to
PULSE.

NOTE:  The # and * buttons have no function in the pulse mode.

SETTING THE DAY AND TIME

The TAD records the day and time of the call with each phone message. 
Follow these steps to set the day and time. 

NOTES:  To avoid resetting the time if AC power is lost, we recommend you 
        install a backup battery before you set the day and time. 

        If you do not complete each step within 8 seconds, the TAD sounds 
        three beeps and stops setting the day and time.  Start again from 
        Step 1. 

1.  Press and hold SET until the TAD beeps.  The TAD announces, "Sunday," 
    and 01 appears on the display. 

    NOTE:  If necessary, adjust VOLUME on the right side of the TAD to 
           the desired listening level. 

2.  Press REPEAT/CODE to set back the day or SKIP/MEMO to advance the day 
    until the TAD announces the desired day of the week. 

    NOTE:  Each time you change the day, the number on the display changes 
           to indicate the day of the week (1-7). 

3.  Press and release PLAY/STOP.  The TAD beeps once and announces the 
    time format.  "AM" or "PM." 

4. Press REPEAT/CODE to set back the hour or SKIP/MEMO to advance the hour 
   to the desired hour. 

5.  Press and release PLAY/STOP.  The TAD beeps once. 

6.  Press REPEAT/CODE to set back the minutes or SKIP/MEMO to advance the 
    minutes to the desired setting. 

7.  After you set the day of the week, the hour, and the minutes, press 
    PLAY/STOP to confirm the settings.  The TAD beeps and announces the day 
    and time. 

    To check the current day/time at any time (except while recording or 
    playing messages), press SET.  The TAD announces the time and "AM" or 
    "PM," and displays the hours and minutes. 


(/all-02/14/96)