ET-330 Cordless Electronic Telephone System
(430-0267)                 Handset                    Faxback Doc. # 19214

OPERATION SUMMARY

Telescopic Antenna - Extends fully to maintain maximum communication range.

Receiver (Behind Grille) - Operates the same as the receiver in a regular
                           telephone. The "ring" from an outside call comes
                           from the receiver, unless an intercom call is in
                           progress.  The Handset also rings when the CALL
                           key on the Base Unit is pressed.  The two rings
                           are different, so that you can tell an outside
                           call from an intercom call.

CAUTION:  Make sure the TALK indicator is on before you put the receiver
          to your ear.  This prevents your receiving a very loud "ring"
          tone in you ear.

PHONE READY/OFF Switch - Turns the Handset on and off.  Set the switch to 
                         READY when you want to make or receive a call.

  [0] through [9] Keys - Dial telephone numbers or enter them into the 
                         memory.

         PAUSE [*] KEY - Adds a pause when entering a number into the
                         memory or when dialing a number that will be
                         redialed using the REDIAL key.  This is sometimes
                         necessary when accessing an outside line from an
                         office.

         REDIAL[#] Key - When pressed, automatically redials the last
                         manually dialed number.

           HANG-UP Key - When pressed, disconnects the Handset from the
                         phone line.  (This is like hanging up a regular
                         telephone.) Press it until the TALK indicator goes
                         off.

              TALK Key - When pressed, connects the Handset to the phone
                         line.  (This is like lifting the receiver on a
                         regular telephone.)  Press it until the TALK
                         indicator lights.

              A/B Keys - When pressed, enters or automatically dials
                         telephone numbers for memory-dialing.  Each memory
                         position will store up to 10 digits.

            MEMORY Key - When pressed, prepares the memory (A or B) for
                         storing a telephone number.

     DC 9V Charge Jack - Provides the connection for charging of the
                         Handset away from the Base Unit.  Connect an AC
                         adapter/charger here (Cat. No. 273-1455).

     Charging Contacts - Receive power from the Base Unit charging contacts
                         when the Handset is on the Base.

   Mic (Behind Grille) - Operates the same as the microphone in a regular
                         telephone.

Important:  If you are returning the Handset to the Base Unit or do not 
            want to make or receive calls, press the HANG-UP key before you 
            move the READY/OFF switch to OFF.  If you do not do this, the 
            phone line will remain active.

           PRIVACY Key - When pressed and held, temporarily disconnects the
                         microphone in the Handset; the phone line remains
                         active, but no sound is transmitted.  Release the
                         key to continue your conversation.

   VOLUME HI/LO Switch - Selects the listening level on the Handset.

   RINGER HI/LO Switch - Selects the ringer loudness level from the
                         Handset.

        TALK Indicator - Lights when the TALK or CALL key is pressed (to
                         indicate the Handset is "on the line").

 BATTery LOW Indicator - Lights when the nickel-cadmium batteries need to
                         be recharged.

NOTE:  The BATT LOW Indicator will flicker when you move the READY/OFF
       switch.  This is normal and does not indicate weak batteries.  The
       batteries need recharging only when the indicator stays on.  Of
       course, if the batteries are allowed to discharge completely, the
       indicator will not light.

              CALL Key - Press to signal the Base Unit (for an intercom
                         call,etc.).


(CS 12/19/95)