Duofone-100 Automatic Telephone Memory Dialer
(430-0279)                 Installation               Faxback Doc. # 19586

Your DUOFONE-100 requires two 1 1/2 volt "AA" penlight cells (not supplied)
to protect the phone numbers stored in the memory.

INSTALLING/REPLACING BATTERIES

Open the battery compartment by pressing tab in the direction of arrow.
Insert 2 "AA" cells (Radio Shack Cat. No. 230-0582).  Be sure to observe
the proper polarity.  Replace the battery compartment door.

CAUTION:  When you change batteries, have the fresh ones ready to put in
          place.  To hold memory, you must have the AC Power Cord connected
          to a source of AC power.

QUICK-CONNECT PHONE LINE INSTALLATION

IMPORTANT:  Before connecting your DUOFONE-100, you must notify your local
            Telephone Company of the registration number and ringer
            equivalence number.  You'll find both of these numbers on the
            bottom of the unit.

The DUOFONE-100 uses modular type connector plugs and jacks (the same ones
required for all new telephone equipment).  It can be used with both rotary
dial and push-button systems.  If your telephone uses the older type 
4-prong receptacles, Radio Shack sells the modular-to-4-prong adapter 
that's necessary to make the conversion.  If your present telephones are
wired directly to the wall, you'll need to update your wiring to the
modular system.  The Telephone Company will do this.

NOTE:  You local Telephone Company is authorized to charge you for the
       installation of such jacks.  They may ask for the U.S.O.C. code
       number for the plug connection; this number is RJ-11C (ask for
       RJ-11W if you want a wall-type jack).

Refer to illustration for cable connection.

1.  Disconnect the existing telephone plug from the wall jack and plug it
    into the PHONE jack on the rear of the DUOFONE-100.

2.  Plug the DUOFONE-100'S telephone cord into the telephone wall jack.


(CS 1/22/96)