SPP-ER1 Cordless Telephone
(430-8006)                 Memory Dialing             Faxback Doc. # 31217

You can program up to 20 numbers into memory for speed dialing (01 to 20).

NOTES:  Make sure that RING ON/BATT SAVE switch on the handset is set to
        RING ON.

        You can program a phone number of up to 16 digits for each speed
        dialing number.  (A */TONE and REDIAL/PAUSE is each counted as one
        digit).

Programming Numbers

1.  Press VOLUME/PROGRAM.  TALK lamp blinks.

2.  Press SPEED DIAL and dialing keys (01 to 20) for speed dialing.
    You will hear a confirmation beep.

3.  Dial the phone number you wish to program.

4.  Press VOLUME/PROGRAM again.  You will hear a long confirmation beep.

To change a programmed number

Program a new number using the procedure above.  The old number will be
erased automatically.

To program REDIAL

You can save a number to be redialed into memory.  This is convenient
when you want to dial the number after dialing a different number.
Directly after you disconnect the number to be redialed, perform the
steps of "Programming Numbers".  Press REDIAL/PAUSE in step 3 above.

NOTES:  If you enter a number that exceeds 16 digits, an alarm will sound.
        Go back to step 1 above.

        Do not let more than 20 seconds elapse between any two steps of the
        programming procedure.

       If you enter a wrong number, go back to step 1 above.

       You cannot program any number when receiving an incoming call, using
       the handset or using the phone as an intercom.

To Make a Call with Speed Dialing

1.  Press TALK.

2.  Press SPEED DIAL.

3.  Press the desired dialing keys for speed dialing (01 to 20).

NOTE:  If you press a dialing key without a phone number programmed, five
       short error beeps will sound.

To Program Numbers for use with a PBX (Private Branch Exchange)

Example:  "If 9 is used to access the outside line

Follow the usual programming procedure as described.  Press REDIAL/PAUSE
between the "9" and the number.  An automatic 4-second pause is 
programmed.

Example:  To program 123-4567 for speed dialing

Press:  VOLUME/PROGRAM -> SPEED DIAL + (01 to 20) for speed dialing (You
        will hear a confirmation beep.) -> 9 -> REDIAL/PAUSE -> 1 2 3 4 5 6
        7 -> VOLUME/PAUSE (you will hear a long confirmation beep.)
        (A REDIAL/PAUSE will be counted as one digit.)

To keep a directory of what you programmed

Lift off the clear panel, take out the directory on the rear of the handset
and write down the name of the person or place whose number you have
programmed.

When you replace the panel, make sure the projections of the panel enter
fully into the slots of the handset.


(CS 3/7/96)