SPP-ER1 Cordless Telephone
(430-8006)                 Installation               Faxback Doc. # 31219

SETTING UP THE BASE UNIT

Complete Set-up
    Clean the battery charge terminals with a soft cloth about once a
    month, otherwise, the handset may not be fully charged.

Telephone Line Connection

    If your telephone jack is not a modular type, please contact your
    telephone company for assistance.

    Connect one end of the telephone line cord (supplied) to telephone line
    jack on the phone and the other end to the wall telephone outlet.

POWER CONNECTION

NOTES:  Connect the AC power adaptor to continuous power supply. If the
        telephone is connected to a wall outlet where power is cut off
        every night, the battery pack will not be charged, and all
        programmed numbers will be lost from memory.  The digital security
        code will also be erased.

        If the digital security code is lost, place the handset on the base
        unit and charge the battery.

Connect one end of the telephone line cord (supplied) to DC IN 9V at back
of phone and the other end of cord to AC power adaptor (supplied) that is
plugged into a wall outlet.  Route the AC power adaptor's cord through the
groove on the back of the base unit to avoid accidental disconnection>  
Be sure to raise the antenna vertically.

SELECTING THE DIAL MODE (pulse or tone)

If you do not know which setting is correct for your telephone line, check
as follows.

1.  Set the DIAL MODE switch located at the rear of the base unit to TONE.

2.  Make a trial call.

3.  If the call is connected, leave the switch at TONE.  Otherwise, set
    the switch to PULSE.

CHARGING THE BATTERY PACK FOR THE HANDSET

Before initial use, charge the supplied battery pack for more than 12
hours.

To charge the battery pack

1.  Remove the battery compartment lid by pushing it downward.

2.  Place the supplied battery pack in the battery compartment and connect
    the cord correctly to the jack.

3.  Replace the battery compartment lid by pushing it upward.

4.  Place the handset on the base unit and charge the battery pack for
    more than 12 hours.  The CHARGE lamp lights when the handset is fully
    seated onto the charge terminals of the base unit.

When To Charge The Battery

As long as the handset is placed back on the base unit after each call, the
battery will be recharged continuously.

If the handset battery becomes weak

    A beep tone will be heard every 3 seconds while you are on the phone.
    The call will be disconnected in one minute.

Battery life

    Replace the battery pack with a new one when the operating time of the
    completely charged battery pack has noticeably shortened.

NOTE:  If the handset battery is completely discharged, the digital
       security code will be erased.  To reset the security code, place the
       handset on the base unit and charge the battery.

MOUNTING YOU PHONE ON THE WALL

1.  Attach the AC adaptor cord and the telephone line cord to the wall
    bracket (using the supplied wall bracket, telephone line cord, and
    AC adaptor).

2.  Hook the bracket to the telephone outlet, and plug the telephone line
    cord into the modular jack.

3.  Attach the supplied hanger piece to the base unit using the supplied
    screw (hanger piece supplied).

4.  Align the slots on the base unit with the inserts on the bracket.  Then
    attach the base unit to the bracket by gently pushing down.  (Connect
    the phone modular plug from the bracket to the telephone line jack on
    phone, the power plug to DC IN 9V jack, and the adaptor to the wall AC
    outlet).

5.  Raise the antenna upward and hang the handset on the hanger piece.

    In step 2, if you cannot hook the bracket, attach it directly to the
    wall using the supplied screws.


(CS 3/7/96)