ET-166 20 Memory Telephone
(430-0852)                 Preparation                Faxback Doc. # 31252

SETTING THE RINGER SWITCH

The ringer switch controls how loud the phone's ring is.  Set the switch
as follows:

TO SOUND:                SET SWITCH TO:

In a Noisy Room          HI
(such as a kitchen

In a Quiet Room          LO
(such as a bedroom)

If you do not want the ringer to sound, set RINGER to OFF.  You can still
make calls, and you can answer calls if you hear another phone on the
same phone line ring.

SETTING THE DIALING MODE

Set PULSE/TONE for the type of service you have, either tone or pulse
(rotary).  If you are not sure, do this simple test.

1.  Set PULSE/TONE to TONE.

2.  Lift the handset and listen for a dial tone.

3.  Press any number except 0.  If the dial tone stops, you have touch-
    tone service.  If the dial tone continues you have pulse service.

4.  If you have pulse service, set PULSE/TONE to PULSE.

    NOTES:  If you have pulse service and want to use a special service
            requiring tone signals (such as bank-by-phone), see "Using
            Tone Services on a Pulse Line", Faxback Doc. # 31251, and
            "Chain Dialing", Faxback Doc # 31251.

            The * and # buttons have no effect when PULSE/TONE is set
            to PULSE.


(SP/LB 3/15/96)