Neon Desktop Squiggle Phone
(430-0834)                 Operation                  Faxback Doc. # 31414

SETTING THE ALARM

Use the knob underneath the phone's base to set the alarm time.  With the
knob pushed in, turn it to set the clock's silver pointer to the desired
alarm time.

    To set the alarm to sound, leave ALARM pressed out.

    To TURN OFF THE ALARM, PRESS IN alarm.

USING MUTE

To speak to someone in the room without the person on the phone hearing,
press and hold MUTE.  To resume you phone conversation release MUTE.

USING REDIAL

To call the last number dialed, press REDIAL.  The redial memory holds up
to 32 digits in the pulse mode, and 31 digits in the tone mode.

USING TONE SERVICES ON A PULSE LINE

Some special services, such as bank-by-phone, require touch-tone signals.
If you have pulse service, you can still use these special tone services
by following these steps.

1.  Set P/T on the left side of the handset to P.

2.  Call the service.

3.  When the service answers, press and release *.

4.  Follow the normal procedures for the service you are using.  Any
    additional numbers you dial are sent as tone signals.

5.  When you complete the call, hang up the handset.  The phone 
    automatically returns to pulse dialing.

NOTE:  You can also change the dialing mode by setting P/T to T anytime
       during the call.  But, you must set it back to P when you hang up.

USING REDIAL FOR TONE SERVICES ON A PULSE LINE

To redial a number that includes a change from pulse to tone dialing (such
as bank-by-phone services), leave P/T set to P and press REDIAL.  The phone
pauses during the mode change, the dials the remaining numbers.

USING FLASH

Many special telephone services require a switchhook signal.  When you
press FLASH, your phone produces an electronic switchhook signal that is
more accurate and more convenient than using the phone's switchhook.

For example, if you subscribe to call waiting, you can press FLASH to put
your current call on hold and take the incoming call.  You can repeatedly
press FLASH to alternate between the two calls.

USING MON

The MON feature lets you dial and monitor the progress of a call without
picking up the handset.

1.  Press MON and wait for a dial tone.  The neon light turns off.

2.  Set MON. VOL. HI/MID/LO on the right side of the base to HI in a
    noisy room, such as the kitchen.

    Set MON.VOL. HI/MID/LO to MID for a medium volume level.

    Set MON.VOL. HI/MID/LO to LO in a quiet room, such as a bedroom.

3.  Dial the phone number you want to call.

4.  When the person you are calling answers, you hear them through the
    built-in speaker.

5.  Lift the handset to begin your conversation.


(CS 3/18/96)