TAD-112 Telephone Answering System
(430-0247)                  Operation                 Faxback Doc. # 31732

REMOTE CONTROL PLAYBACK

When using the Remote Control, place the grille directly against the
telephone's mouthpiece.  To hear messages you have received, do the
following:

1.  Call your phone.  Listen for your outgoing message on your TAD.

2.  While the outgoing message is playing, press the button on the remote
    control for a couple of seconds.

3.  The TAD will rewind and begin playing all messages (it might take up
    to a minute and a half to rewind if the tape is full).

4.  When you have heard all the messages, press button on the remote
    control again.

5.  The outgoing message will start playing again.  You can now hang up
    the telephone and your TAD will return to the ANSWER mode (all
    messages will be retained on the tape, with none being erased or none
    being recorded over).

NOTE:  If you have heard all the messages and wish to record a message on
       the TAD at this point, wait till the outgoing message ceases.
       Speak your message into the phone.  Then hang up the phone.


(IR-04/10/96)