Mobile Mounting Kit for CT-302
(170-0606)                 Installation               Faxback Doc. # 32775

The mounting bracket's location is very important.  Choose a mounting
location that:

    Does not interfere with the operation of the vehicle

    Does not increase the possibility of an accident

    Provides a solid surface for mounting the base

    Lets you mount the base without damaging objects on the other side of
    the mounting surface

    Provides easy access to the phone and Cigarette-lighter plug

    Permits convenient routing of the cigarette-lighter adapter power cord

You can assemble the mounting bracket with both extension arms, either
extension arm, or no extension arms.  In some cases, it is best to attach
only the telephone holder with the supplied pan-head self-tapping screws. 
This flexibility of assembly and the proper choice of the mounting location
lets you install the bracket in almost any vehicle.

After you choose a mounting location, follow these steps:

1.  Use the base as a template to mark the positions for the four screw
    holes.

2.  Drill 1/8-inch (or slightly larger) holes at each of the marked
    locations.

    CAUTION:  Be sure not to drill into objects on the other side of the
              mounting surface.

3.  Position the base over the holes and install the four hex-head self-
    tapping screws.  Use a Phillips-head Screwdriver or a 5/16-inch Socket
    Wrench to tighten the screws.  Use the base spacer if you mount the
    base on a curved surface.

    CAUTION:  Be sure the screws do not extend into objects on the other
              side of the mounting surface.   To prevent this, you might
              need to use shorter self-tapping screws (not supplied).

4.  Position the base swivel on the base, and attach it with a lock washer
    and a hex-head bolt.  Use the supplied hex-head wrench to tighten the
    bolt.

5.  Attach one or two extension arms according to the mounting area using
    lock washers and hex-head bolts.

    If desired, you can attach the telephone holder and the bracket to the
    base swivel without extension arms.

6.  Attach the telephone holder and the holder bracket with the panhead
    bolts and nuts.

Be sure to mount the telephone holder with its stops toward the bottom.


(ALL-05/15/96)