Entrance Bridge
(279-0394)                 Installation               Faxback Doc. # 34113

Instructions

1.  Position Entrance Bridge next to Network Interface and fasten with the
    two screws.

2.  Run line to the Entrance Bridge.  Leave at least 8" for connection.

3.  Fasten either existing phone wires or new color-coded phone wire to
    screws per markings -- red to red, green to green, etc.

NOTES:  For typical single-line installation (RJ11) use Red & Green
        Terminals.

        For typical 2-line installation (RJ14):
           Line 1 -- Use Red & Green Terminals
           Line 2 -- Use Yellow & Black Terminals

4.  With a sharp pocket knife or hobby knife, carefully cut break-out tab
    (either side depending on location).

5.  Place cover over Bridge and tighten cover screw.

6.  Connect modular plug into Network Interface jack.


(BR/EB 7/12/96)