Sony Clear Scan-25 2-line Cordless (430-8008) Advanced Features Faxback Doc. # 34123 Speed dialing You can dial with a touch of a few keys by storing a phone number on a dialing key. Storing phone numbers 1. Press (PGM). The left lamp flashes. 2. Press (speed dial). 3. Press one of the dialing keys (0 to 9) to store a phone number on. You hear a confirmation beep. 4. Enter the phone number you want to store. You can enter up to 16 digits, including a tone and a pause, each of which is counted as one digit. 5. Press (PGM). You hear a long confirmation beep, and the number stored. The lamp goes off. NOTE: Do not allow more than 20 seconds to elapse between each step of the procedure. TIPS: If you enter a wrong number, press (PGM), then start from the beginning. You can attach the supplied directory on the handset. Do not cover the ringer hole. You can't receive calls while you're storing numbers. To store a number to be dialed via Private Branch Exchange (PBX) Before entering a phone number in Step 4, do as follows: 1. Enter the outside line access digit (e.g., 9). 2. Press (REDIAL/PAUSE). To change a stored number Store a new number, as described above. Making calls with speed dialing 1. Press (LINE 1) or (LINE 2) to select the line and wait until the corresponding line lamp lights up. 2. Press (SPEED DIAL). 3. Enter the desired speed dialing number (0 to 9). The phone number stored in the speed dialing number will be dialed. Paging You can page the handset from the base unit. Note that you can't page if the handset is in use. To page Press (PAGE). The handset rings. When you keep pressing (PAGE), the handset rings continuously. NOTE: You can't page the handset when the RING ON/BATT SAVE switch is set to BATT SAVE. Resetting the digital security code Since a random security code is automatically assigned between the base unit and the handset when you charge the battery pack for the first time, you normally do not need to reset the security code. However, in the unlikely event that you suspect that another cordless phone uses the same security code, you can manually change the code. Pick up the handset from the base unit, and proceed as follows: 1. Press (PGM). The left lamp flashes. 2. Press (#). You hear a confirmation beep. 3. Press three of the dialing keys (001 to 339) to store a new code. 4. Press (PGM). You hear a long confirmation beep and the lamp goes off. 5. Immediately replace the handset on the base unit. You hear a long confirmation beep and the phone stores the new code. NOTE: If the battery pack in the handset is completely discharged, or is removed from the handset for more than several seconds, the digital security code stored will be lost. If this happens, charge the battery pack and a new security code will be automatically assigned. TIP: This procedure will change the code in both the base unit and the handset. The code can be changed as often as desired. (BR/EB 7/8/96)