NOKIA-232 Cellular Telephone (170-1986) Display Messages Faxback Doc. # 34238 REFERENCE INFORMATION LIST OF DISPLAY MESSAGES AUTO PWR OFF Phone is installed in a car kit with ignition sense connected. When ignition is switched off, this message appears, and the phone will switch off automatically in 5 seconds. BATTERY LOW Appears when battery charge is down to approximately 5%, then every 5 minutes if phone is in standby mode, or every minute if it is in a call. CALL Indicates that you are receiving a call, or have not answered an incoming call. CALL IN PROGRESS Appears if you try to change from one cellular network to another in mid call. CODE ERROR Indicates that you have entered an invalid lock code or security code. DATA ACTIVE The phone is in data mode. EMPTY Displayed when you try to recall information from an empty memory location. KEYGUARD ACTIVE The keyguard function is switched on. KEYGUARD OFF The keyguard function is switched off. LOCATION FULL The memory location to which you are trying to move information is already occupied. LOCK CODE? Enter your 4-digit lock code (default 1234). LOCKED The phone is locked. MOVE NAME? Displayed if you are trying to store a name which already exists, or are moving stored contents which include a name. NAM ERROR The NAM contains erroneous data; contact your dealer. NAME? Enter a name (you have selected alpha mode). NAME TOO LONG The name you have entered will not fit completely in the memory location and will be truncated (press STO again to accept the shortened name). NEW CODE? Enter a new lock code. NONE PRESENT There are no accessories connected to the phone. NO CALL ACTIVE Data mode cannot be used as there is no call in progress. NO ROOM FOR NAME The associated number in the selected memory location is too long to allow space for a name (press STO again to proceed. NO SERVICE Appears if you try to make a call when no cellular service is available. NO SPACE Indicates that all memory locations are full. NOT ALLOWED Indicates that you have tried to store a number in an invalid memory (i.e., 00) or call a barred number. NOT FOUND Indicates that the name you are trying to recall does not exist. PRESS "MENU" and NOW TYPE "*" A key was pressed while keyguard was active; to switch off keyguard, press MENU then *. RECALL Prompts you to enter the desired memory location number, when wishing to recall information from the memory. RECHARGE BATTERY Appears for 10 seconds before the phone switches off automatically. REPLACE CONTENT? Indicates that the memory location in which you are trying to store is already in use. SECURITY? Enter the security code (default 12345). SILENT Indicates that the ringing tone is switched off (i.e. 'SILENT SERVICE' option is selected). SID SCRN BARRED (NO flashes, SVC steady) No service is available due to SID function (Menu 18), To attempt to regain service, set SID SCRN to OFF. STORE Prompts you to enter a memory location number, when storing or deleting contents. STORE NOT DONE Indicates that you chose not to store new information in a memory location that was already occupied. STORED Indicates that storing to memory was successful. TIMERS CLEARED Indicates that call timers have been set to zero. UNLOCKED The phone has been unlocked. USE /\ AND \/ TO VIEW Indicates that you have entered the menu; press /\ or \/ to scroll the functions. VOLUME 1 Indicates the earpiece volume selected. LIST OF TONES Ringing Tone: This denotes an incoming call. The tone volume can be selected using Menu 6, and the ring-tone type can be selected using Menu 2. Keypress Tone: This (single) tone denotes a valid keypress. Re-order Tone: This (triple) tone indicates that your attempt to originate a call was unsuccessful (i.e., the network was busy) or your call has been terminated for some other reason. Low Battery Tone: This (single) tone denotes that the remaining battery charge is low. The BATTERY LOW message is displayed at the same time. The tone sounds every 5 minutes if phone is in standby mode, or every minute if in a call. Recharge Battery Tone: This (Triple) tone denotes that battery charge is extremely low, and that the phone will no longer operate. The RECHARGE BATTERY message is displayed at the same time. The phone will switch off automatically within 10 seconds. Charger-connected Tone: This tone (single beep) denotes that a charger has been connected; charging may start. The tone will be heard even when phone is switched off. Auto Power-off Tone: In a car kit equipped with ignition sense, this tone denotes that the power will be switched off automatically. The AUTO PWR OFF message is displayed at the same time. Error Tone: This (long) tone indicates that cellular service cannot be obtained (e.g. you are not within the service area). In a car kit equipped with ignition sense, the tone denotes that the phone will switch off automatically in 5 seconds. (LB/EB 07/19/96)