Telephone Hold Module (430-0232) Operation Faxback Doc. # 34399 1. To put a call on "hold", depress the phone's switchhook twice for about 1/2 second each. Be sure no other phones are in use or the hold function will not operate. 2. You should hear a short series of tones; this is your signal that the hold circuit has been activated. 3. Hang up the phone. 4. To resume conversation, pick up any extension phone on the same line. This automatically disengages the hold function. NOTE: This unit has a built-in automatic six minute reset. If you should put a call on hold and forget to pick up one of the extensions, the hold circuit will automatically disengage after approximately six minutes, clearing your phone line for incoming calls. (IR-08/26/96)