ET-291 Two-Line Trim-Fone Telephone
(430-0621)                 Preparation                Faxback Doc. # 34504

Complete these steps after installing your phone.

Setting the TONE/PULSE switch

Set the TONE/PULSE switch for the type of service you have.  If you are
not sure which type of service you have, do this simple test:

1.  Set the TONE/PULSE switch to TONE.

2.  Press [LINE 1].

3.  Lift the handset and listen for a dial tone.

4.  Press any number other than 0.

    If the dial tone stops, you have touch-tone service on that line.

5.  Press [LINE 2], and repeat Steps 3 and 4.

6.  If you have pulse service on either line, set the switch to PULSE.

Setting the ringer HI/LO/OFF switch

Set the volume for each line's ringer.  Set the switch to HI in a noisy
room, such as the kitchen.  Set it to LO in a quiet room, such as a bedroom

If you do not want a ringer to sound, set the switch to OFF.  You can
still receive and make calls from that line.  The green indicator flashes
when you receive a call. 

CONFIRMING LINE NUMBERS

To determine the phone number for each line, press [LINE 1], life the
handset, and dial one of the phone numbers.

If the green indicator for Line 2 flashes, the number you dialed is for
Line 2.  If you hear a busy signal, the number is for Line 1.

Write the phone numbers in the spaces provided on the handset's cradle.

NOTE:  If you have Rollover (Hunt), ask someone to call one of the phone
       numbers from a third phone line and note which green indicator
       flashes.


(YO/EB 9/3/96)