ET-291 Two-Line Trim-Fone Telephone
(430-0621)                 Operation                  Faxback Doc. # 34505

This section gives instructions for using your phone.

RECEIVING A CALL

When you receive a call, that line's green indicator flashes.  To answer a
call, press the line button next to the flashing green indicator and lift
the handset.

PLACING A CALL

1.  Press the line button for a line that is not in use.

2.  Lift the handset and listen for a dial tone.

3.  Dial the number.

NOTE:  If you are using pulse service, it takes the phone a few seconds to
       finish dialing.

USING RESET

To disconnect a call without hanging up the handset, press [RESET] and hold
it for about one second.

USING REDIAL

To redial the last number you dialed.

1.  Press [RESET].

2.  Press the button for a line not in use, and listen for a dial tone.

3.  Press [REDIAL].

The redial memory holds up to 32 digits, so it can store long-distance
numbers as well as local numbers.

PUTTING A CALL ON HOLD

Placing a call on hold lets you hang up the handset or use the other phone
line without disconnecting the first line.

To place a call on hold, press [HOLD].  The line's red indicator light
comes on.

To release a line from hold so that you can continue the conversation,
press that line's button.  You can also release a call from hold by picking
up any extension phone on that line.

MAKING A CONFERENCE CALL

A conference call lets you have a three-way conversation.  To place a
conference call, do the following:

1.  Place a call to one of the parties.

2.  Press [HOLD] to put the first call on hold.

3.  On the other phone line, place a call to the other party.

4.  After the second party answers, press [CONF].  This connects all three
    parties.

NOTE:  During conference calls, long-distance calls might sound weaker than
       local calls.

USING HOLD DURING A CONFERENCE CALL

To talk on only one line without disconnecting the other line, press [HOLD]
Both red indicators come on.  Then, press the button for the line you want
to talk on.

To return to the three-way conversation, press [CONF].

DISCONNECTING ONE LINE DURING A CONFERENCE CALL

To disconnect one line and continue talking on the other, press the button
for the line you want to talk on.  This disconnects the other line if it is
not placed on hold.

USING TONE SERVICES ON A PULSE LINE

Some special services, such as bank-by-phone, require tone signals.  If you
have pulse service, you can still use these special tone services by
following these steps:

1.  Be sure your phone's TONE/PULSE switch is set to PULSE.

2.  Call the service.

3.  When the service answers, set the TONE/PULSE switch to TONE.

4.  Follow the normal procedures for the service you are using.  Any
    additional numbers dialed are sent by tone signal.

5.  When you complete the call, set the TONE/PULSE switch to PULSE and hang
    up.

USING REDIAL FOR TONE SERVICES ON A PULSE LINE

To redial a number that includes a change from PULSE to TONE, leave the
TONE/PULSE switch set to PULSE and press [REDIAL].

The phone stops redialing at the mode change.

Simply press [REDIAL] a second time to dial the remaining numbers.


(YO/EB 9/3/96)