TAD-412  (430-0399)            Beep Codes               Faxback Doc. # 6152

SYMPTOM                           SOLUTION
───────────────────────────────────────────────────────────────────────────
Eight short beeps sound:
───────────────────────────────────────────────────────────────────────────
When you press [ANNOUNCE          (Outgoing-announcement tape is missing.)
RECORD].                          Install tape.
───────────────────────────────────────────────────────────────────────────
When you press [ANSWER],          (Incoming-message tape is missing.)
[PLAY], [REWIND], [FAST-F],       Install tape.
[ERASE] REWIND], or [MEMO].
───────────────────────────────────────────────────────────────────────────
When you press [REWIND],          (INCOMING MESSAGE switch is set to
[FAST-F], or [ERASE REWIND].      ANN. ONLY.)  Set to correct position.
───────────────────────────────────────────────────────────────────────────
When your press [ERASE            (Incoming-message tape is at the be
REWIND] or [REWIND].              beginning.)  Press [PLAY] or [FAST-F].
───────────────────────────────────────────────────────────────────────────
Eight short beeps sounds and the  (Incoming-message tape ends before
ANSWER and MEMO indicators        caller completes recording.)  Replace
flash.                            tape.

                                  (Outgoing-announcement tape ends and
                                  rewinds before recording is complete.)
                                  Replace tape with one of correct length.

                                  (One or both tapes are torn.)  Replace
                                  tape.
───────────────────────────────────────────────────────────────────────────
ANSWER AND MEMO indicators        (Possible internal circuitry  or tape
blink after problem is corrected. mechanism error.)

                                  1.  Press [STOP],  2.  Turn the VOLUME/
                                  Power control off, then back on.
                                  3.  Disconnect, then reconnect the
                                  adapter.
───────────────────────────────────────────────────────────────────────────
Eight short beeps sound when      (Code was not entered within the required
security code is being entered.   7 seconds.)  Reenter following correct
                                  steps within the allotted 7 seconds.
───────────────────────────────────────────────────────────────────────────
Eight short beeps sounds when     (You are at the end of the incoming-
you attempt remote control        message tape.  The tape is full.)  To
operation.                        hear the message, enter your security
                                  code within 7 seconds of the beeps.
                                  The new message group automatically
                                  rewinds and plays back.
───────────────────────────────────────────────────────────────────────────

(RLR-02-24-94)