TAD-265 Cordless Telephone Answering System
(430-0730)                 Memory Dialing             Faxback Doc. # 6157

You can store up to 10 telephone numbers in memory.  You can then dial a
stored number by entering a one-digit memory-location code.  Each number
you store can be up to 16 digits long.

Storing a Number in Memory

To store a number in memory, do the following.

1.  Set TONE/PULSE for the type of service you have.

2.  Turn off all indicators on the  handset and base.  (Press TALK to turn
    off the talk indicator; press STOP to turn off the answer indicator.)

3.  Press # then MEMORY.  The HOLD/INTERCOM indicator starts to blink
    and a beep sounds.

4.  Enter the number of the memory location where you want the phone number
    to be stored using the number keys (0-9).

    4-1  Enter the phone number and any PAUSE and TONE entries.

    NOTE:  Each PAUSE or TONE entry uses one digit of the system's 16-digit
           memory.

5.  Press MEMORY to store the number into the selected location.  A long
    beep sounds and the HOLD/INTERCOM indicator turns off.

To store more numbers, repeat Steps 2-5.

NOTES:  If you receive a call while you are storing a number in memory,
        press TALK to answer the call.  After the call, begin again at Step
        2 to store the number.

        To delete a number from memory, repeat all Steps except 4-1 in
        "Storing a Number in Memory."

Entering a Pause

In some telephone systems, you must dial an access code (9, for example)
and wait for a second dial tone before you can dial an outside number.
You can store the access code with the phone number.  However, you must
also store a pause after the access code to allow the outside line time
to connect.  To do so, press REDIAL/PAUSE to enter a 2-second pause.  For
a longer pause, press REDIAL/PAUSE additional times.

DIALING a Memory Number

Follow these steps to dial a number stored in memory.

1.  Lift the handset from the cradle, or press TALK.

2.  When you hear a dial tone, press MEMORY and then enter the memory-
    location code.

When programming emergency numbers or making test calls to emergency
numbers:

    Remain on the line and briefly explain the reason for the call before
    you hang up.

    Perform such activities in the off-peak hours, such as early mornings
    or late evenings.

Chain-Dialing Memory Numbers

When you use special services such as alternate long-distance or bank-by-
phone, you can store the service's phone number in one memory location,
your security code (if you have one) in another location, and any other
numbers, such as the long-distance number, in a third location.  This lets
you easily dial a long sequence of numbers.

To chain-dial memory numbers, follow these steps.

1.  Press MEMORY and the memory-location code for the service's main
    number.

2.  Wait for the service to answer.

3.  Press MEMORY and the memory-location code for your security code (if
    necessary).

4.  Press MEMORY and memory-location code for the remaining numbers.

NOTE:  If you use pulse dialing to dial the service, after the service
       answers, press TONE before you enter memory location codes.  Or,
       enter TONE when you store the number into memory.