5-Volt/3 Amp Power  (277-0119)       Preparation       Faxback Doc. # 15757
Supply

The Cabinet selected for this Project-Board will give your completed unit
a professional appearance when assembled.  Mounting parts will be easy
because you receive the Cabinet completely disassembled.

To aid you in the Cabinet Preparation, you should have a center punch,
power drill, nibbling tool and a small wrench set or nut drivers.

Drill Templates have been provided on separate sheets for Front, Rear and
Bottom Panel.  WE RECOMMEND THAT YOU CLAMP THE PANELS TO YOUR WORKBENCH
BEFORE DRILLING HOLES TO KEEP THE PANELS FROM ROTATING WITH THE DRILL BIT.

    Remove the Cabinet from its package and study the assembly
    illustrations.

    Tape the Front Panel Drill Template to the Front Panel.

    Center punch the holes and drill or cut them out.

    Tape the Rear Panel Drill Template to the Rear Panel.

    Center punch and drill out the holes.

    Tape the Bottom Panel Drill Template to the Bottom Panel.

    Center punch and drill out the holes.

    Deburr all holes with a small file.

    Assemble feet to Bottom Panel  (see Illustration II of Cabinet
    Assembly instructions).

    Remove the paper backing from the Front Panel Label.

    Align the Front Panel Label over the Front Panel and gently press into
    place.

    Next, change the Meter Face Plate (you received a Face Plate in your
    Project-Board package).  Use caution to prevent damaging the meter
    pointer during the following steps.

    Remove the Plastic Face Plate cover from the Meter.  Be careful not to
    scratch the plastic cover.  The cover snaps onto the meter case.  Use a
    small common screwdriver to pry the top of the cover loose.

Caution:  Perform the following steps in a clean area.  Because of the
          magnet in the meter be sure there are no metal filings in your
          work area and be careful not to drop the screws into the meter
          opening.

    Remove the screws holding the metal Face Plate.

    Place the metal Face Plate on a flat surface and align the new Face
    Plate.

    Remove the paper backing from the new Meter Face Plate.

    Be sure the new Face Plate is aligned as accurately as possible, then
    smooth it out over the metal plate.

    Position the metal Face Plate back on the Meter and secure it with
    screws removed earlier.

    Be sure the pin on the Meter adjustment screw is aligned with the slot
    in the adjustment tab and carefully reinstall the plastic Face Plate
    cover.

    Remove shorting wire from between meter terminals.


(br/all-06/28/95)