Wireless Door Chime  (630-0872)      Installation      Faxback Doc. # 16484

SELECTING MOUNTING LOCATIONS FOR THE TRANSMITTERS

The door chime has two transmitters, one for the front and one for the rear
door.  Select a location for each transmitter where:

    The mounting surface will hold the supplied screw anchors.

    Visitors and deliver people can easily see and reach it.

NOTE:  The transmitters might not operate properly if mounted directly on
       metal surfaces.  For the best results, place a small, thin non-
       metallic pad beneath each transmitter.

MOUNTING THE TRANSMITTERS

1.  Using the transmitter as a template, mark the positions of the two
    screw holes at the selected mounting location.

2.  Drill two 1/4-inch holes in the marked positions.

3.  Hammer the supplied screw anchors into the holes.

4.  Place the A transmitter (labeled CODE A on the back) with the LED
    indicator above the button and with the holes in its case aligned with
    the screw anchors.

5.  Insert the supplied screws through the holes in the A transmitter's
    case, and tighten the screws.

6.  Repeat Steps 1-5 for the B transmitter (labeled CODE B on the back).

MOUNTING THE RECEIVER

You can mount the receiver in a convenient place in your home or business,
or you can use the clip to attach it to your belt or pocket when you are
working outside.

Follow these steps to mount the receiver:

1.  Drive a screw or nail (not supplied) with a head that fits the
    receiver's keyhole slot into the wall at the desired location.

2.  Place the clip's keyhole slot over the head of the screw and slide the
    receiver down to latch onto the screw.

USING THE RECEIVER'S CLIP AS A STAND

You can use the receiver's clip as a stand to position the receiver on any
flat surface.  Simply hold the receiver upright, press in the top of its
clip, and shake it.  The wire support falls into the notch on the bottom of
the clip.


(ALL-08/15/95)