24 Hour Easy Set Clock Face Timer
(610-1070)                 Operation                  Faxback Doc. # 32085

TO SET THE TIMER:

1.  Press the ON (GREEN) and OFF (RED) trippers (B) onto the dial at the
    desired on and off times.

2.  To set the current time, turn the dial clockwise until the clock face
    in the center shows the desired time.

3.  Plug the desired device into the outlet on the side of the timer, then
    turn on the device.

4.  To start the timer, plug it into an AC outlet.

NOTE:  After a power failure, reset the current time.

MANUAL OPERATION:  To turn the connected device on or off at any time,
                   turn ON/OFF (A) counterclockwise.  The timer
                   automatically turns the device on or off again when it
                   reaches the next on or off tripper on the dial.

CAUTION:  WATTAGE OF LAMP OR APPLIANCES BEING CONTROLLED SHOULD NOT
          EXCEED CAPACITY OF TIMER.  WHEN USED WITH EXTENSION CORD OR
          DEVICES, DO NOT EXCEED THEIR RATING OR 15 AMPS.


(EB 4/19/96)
(WL 4/1/96)