Pocketvision-34  (160-0171)         Operation          Faxback Doc. # 15079
Color TV

CONNECTING AN EXTERNAL ANTENNA

If you are in an area with weak TV signals, or are inside a metal or
concrete building, you might need an external outdoor antenna to improve
reception.  Connect the antenna to the EXT ANT jack.

If the antenna wire is 75-ohm coaxial cable, use an F-to-mini plug adapter
to complete the connection.  We recommend Radio Shack Cat. No. 278-257.
If you have 300-ohm wire, use a 300-to-75-ohm mini plug adapter.  We
recommend Cat. No. 15-1148.

USING THE TV

1.  Extend the rod antenna (unless you are using an external antenna).

2.  Set UHF/VHF/OFF to VHF or UHF.  The TV starts scanning and stops at
    the next active channel in the selected band.

3.  Press TUNING < OR > to tune to a different channel.  The tuning line
    on the screen aligns with the selected channel number below the
    screen.

4.  Adjust VOLUME.

5.  Adjust BRIGHT for the desired brightness.  The brightness also changes
    with the screen's angle.

NOTES:  If desired, fold out the stand on the back of the TV and lean the
        TV on a flat surface at a convenient viewing angle.

        If reception is poor, adjust the length or angle of the rod
        antenna.  If inside a metal or concrete building, moving closer to
        a window might improve reception.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it
might be slightly red in color.  This is not a malfunction.  Normal
operation resumes after a short while.

USING AN EARPHONE

For private listening, you can connect an optional earphone with a
1/8-inch plug to the EAR jack.  This automatically mutes the built-in
speaker.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening.
           Then adjust the volume to a comfortable level.

           Do not wear an earphone while operating a motor vehicle or
           riding a bicycle.  This can cause a traffic hazard and is
           illegal in some areas.


(TE/all-04/28/95)