DSS System II (160-2531) Assembly Faxback Doc. # 15580 Carefully unpack the DSS Satellite Dish Antenna carton. The contents of the carton are described below. If all parts are not in the carton, call 1-800-679-4776. The DSS dish carton contains the following part: Mounting foot assembly and mast Dish (or reflector) LNB (Low Noise Block) converter LNB support arm assembly Hardware packet Assembly the Dish The bolts you need to assemble the dish are in the plastic packet that came in the DSS dish carton. As you handle the dish parts, avoid scratching the surface. Scratches can damage the protective surface. Most of the dish parts were preassembled for you at the factory. You will be given detailed instructions in this guide for any required assembly. Attaching the Dish to the LNB Support Arm 1. Locate the four flat-head screws and the four self-locking nuts from the hardware packet that came with the DSS dish. 2. Press the mounting bracket of the LNB support arm to the back of the dish, matching the four square holes on the bracket to those on the dish. 3. Insert a flat-head screw into one of the holes in the face of the dish and gently press it through the matching hole in the mounting bracket. The wide flat head of the screw is on the inside of the dish. 4. Lightly screw a self-locking nut on the portion of the screw that sticks through the back of the dish and mounting bracket. 5. Repeat steps 3 and 4 for the remaining three flat-head screws and self- locking nuts. 6. Tighten the four self-locking nuts. The heads of the flat-head screws must be flat on the inside surface of the dish for the dish to be securely fastened to the LNB support arm. (TE/all-07/11/95)