Color Enhancement Light  (160-2026)     Operation      Faxback Doc. # 16178

USING THE LIGHT

To brighten the natural colors in a scene.

1.  Slide the light onto the accessory shoe.  Be sure it locks into place.

2.  Press LIGHT to turn on the light.

    WARNING:  The light becomes hot during operation.  Do not touch it
              until it cools.

3.  To remove the light, press LIGHT RELEASE and slide the light out of the
    mount.

REPLACING THE BULB

1.  Turn the screw on the underside of the bulb housing counterclockwise to
    remove it.

2.  Turn the reflector casing counterclockwise, and pull it off the bulb
    casing.

3.  Using a clean cloth or tissue, replace the bulb.  You can order a new
    bulb from your local Radio Shack store.

4.  Replace the reflector casing, turning it clockwise.  Then replace the
    screw.

DANGER:  When replacing the bulb, use only lamp bulbs (Part No. VLLW0003)
         supplied by Radio Shack to reduce the risk of fire.  To prevent
         possible burn hazard, disconnect the Color Enhancement Light Unit
         and allow the lamp to cool before replacing.

         Do not connect any light other than the standard light.  Use of a
         different light, modifications to the light connector or light
         jack may cause severe battery drain and fire hazard.

CAUTIONS:  If using the Enhancement Light for an extended period of time,
           be sure to provide ventilation when using in a hot environment.

           Using the Enhancement Light when the camcorder is powered by a
           car battery may shorten bulb life.

           Do not attempt to lift or carry the camcorder by holding the
           Enhancement Light.


(ALL-07/26/95)