70-Channel Remote Control Cable Converter
(150-1287)                 Operation                  Faxback Doc. # 18384

OPERATING THE CONVERTER

Power Cord - plug into a standard AC outlet (120V, 60Hz).

[POWER] - press to turn the converter and the SWITCHED AC outlet on or
          off.

CHANNEL [\/]/[/\] Buttons - press to select or scan channels in the 
                            direction of the arrow.  The lighted digital 
                            display shows the selected channel.

OPERATING THE REMOTE CONTROL

The remote control allows you to operate your converter from across the
room.  For the most dependable operation, point the remote control toward
the converter's display.

[POWER] - press to turn the converter and the SWITCHED AC outlet on and
          off.

Number Buttons (0-9) - press to directly select channels.  You must precede
                       single-digit channels with a 0 (02, 03, 04, and so
                       on).

CHANNEL [\/]/[/\] Buttons - press to select or scan channels in the 
                            direction of the arrow.  The converter's
                            display shows the channel number.

FINE TUNING [+]/[-] Buttons - press to help you receive the best possible
                              reception.  You only need to make this
                              adjustment when you first use your cable
                              converter.  The converter has a memory that
                              stores the adjustment you make and fine tunes
                              all cable channels you select.

[FLASH BACK] - press to recall the channel you selected before the current
               channel.

[TIMER] - press to set your converter's internal timer to automatically
          turn off the converter and its SWITCHED AC outlet after 10, 20,
          30 minutes, and so on, up to 90 minutes.  The display momentarily
          shows the length of time you choose before the timer starts
          counting.  To see the remaining time on the timer, press [TIMER]
          once.

VARIATION IN CHANNEL NUMBERING

Some cable companies use a channel numbering system different from your
converter.  For example, the channel your cable company calls 21 might be
18 on the converter's display.

Use the channel number labels on the converter and remote control to mark
the cable company's channel numbers when they differ from the converter's
display.

REMOTE CONTROL TVs

If your TV has a remote control, and your converter's remote control
interferes with the TV's operation, either turn off the TV's remote control
feature (if the TV has a remote control on/off switch) or put a piece of
black tape over the TV's remote control receiver window.

If your TV uses an ultrasonic remote control system, there should not be
any interference problems.


(CS 11/29/95)