Model 151 MovieCorder
(160-0852)                 Playback On A TV           Faxback Doc. # 18473

If you have a separate 8mm VCR, you can play the camcorder's tapes on that
VCR.  However, if the camcorder is your only 8mm component, the following
procedures tell you how to playback tapes from the camcorder through a
standard TV or a TV monitor.

Connection to a Standard TV

1.  Connect the supplied RF adapter's multi-pin plug to the camcorder's AV
    OUT jack.

2.  Disconnect the VHF antenna/cable wire from your TV, and connect that
    wire to the RF adapter's VHF IN jack.

3.  Using the supplied coaxial cable, connect the adapter's VHF OUT jack
    and the TV's VHF antenna terminal.

    If your TV only has 300-Ohm screw terminals for VHF, connect a
    matching transformer between the coaxial cable and TV's antenna
    terminal.

4.  Set the RF adapter's CHANNEL switch to CH3 or CH4.

    Either setting will work, but, if possible, choose a channel that is
    not used for regular TV broadcasts in your area.

5.  Set the TV's tuner to the same channel as the RF adapter's CHANNEL
    switch.

    When you turn on the camcorder, its signals are sent to the TV.

    When you turn off or disconnect the camcorder, the antenna/cable
    signals are sent to the TV.  Set the TV tuner as usual.

Connection to a TV Monitor

A TV monitor is a TV that has separate audio/video inputs.

1.  Connect the audio/video output cable's multi-pin plug to the
    camcorder's AV OUT jack.

2.  Connect the audio/video output cable's video plug (yellow) to the
    TV's video input.

3.  Connect the audio/video output cable's audio plug (white) to the TV's
    audio input.

    If your TV monitor is stereo, use a Y-adapter to connect the white
    plug to both audio inputs.

4.  Set the TV to video mode to watch playback from the camcorder.

Playback

After you connect the camcorder to your TV or TV monitor, play a tape as
follows:

1.  Turn on the TV and the camcorder.

2.  Insert a pre-recorded tape into the camcorder.

3.  Prepare the TV to receive the camcorder signals.  (Set your standard
    TV to Channel 3 or 4, or set your TV monitor to the video mode.

4.  Press [PLAY] on the camcorder.

    Press [STOP] to end playback, and press [EJECT] to remove the tape.


(CS 11/6/95)