RF Modulator
(150-1283)                  Operation                  Faxback Doc. # 18686

1.  Turn on the TV and set it to either channel 3 or 4, whichever of the
    two is not used for regular broadcasts in your area.

2.  Set the RF modulator's CHANNEL 4/3 switch to the same channel you set
    on the TV (3 or 4).

3.  To select the VHF source (cable TV or antenna) connected to the RF
    Modulator's ANT IN terminal, set MOD/ANT to ANT.

    To select the audio/video source (VCR or video camera) connected to
    the RF Modulator's AUDIO IN/VIDEO IN terminals, set MOD/ANT to MOD.

    NOTES:  The first time you set MOD/ANT to MOD, turn on the input source
            connected to the RF Modulator's AUDIO IN/VIDEO IN terminals,
            then set OHMS 1K/75 on the RF Modulator to the position that
            gives the best picture.

            For the best results, try both positions to find the best
            setting.  Doing so does not harm your equipment.


(CS 12/4/95)