Wireless Audio/Video  (150-1958)      Operation        Faxback Doc. # 3875
Distribution System

To use your audio/video distribution system, do the following:

1.  Plug in the receiver and the transmitter, and press their POWER
    buttons to turn them on.

2.  Set the transmitter's AV IN-CABLE IN switch to the source you want to 
    send to the receiver.

    If you choose the CABLE IN setting, set the cable box to the desired
    channel.

    If you choose the AV IN setting, begin play of a tape.

3.  Turn on the remote TV and set it to the same channel as the receiver's
    CH3/CH4 switch.

4.  Adjust the receiver's FINE TUNE control for best reception.

NOTES:  When you turn off the receiver, the connected antenna signals pass
        through to the TV.

        If you have problems with interference from other radio
        transmitters, move the SYSTEM CODE switches to the other
        positions.

        You can special order addition receivers at Radio Shack so you can
        send receive the transmitter's signals on more than one remote TV.

        The system's range can vary depending on the locations of the
        transmitter and receiver, and the construction of the building
        they are in.

(ALL-12/29/94)