Model 101  (160-0539)             Viewing TV            Faxback Doc. # 3929

VIEWING TV USING THE TV'S TUNER

Turn off the VCR, or press TV/VCR on the remote control until VCR does not
appear on the VCR's display.  If you are using a TV/monitor connected to
the VCR's AUDIO/VIDEO OUT jacks, be sure to set it to the TV mode.  The
antenna or cable signals pass through the VCR unaffected, as if the
antenna or cable were connected directly to the TV.  Use the TV as you
normally would.

VIEWING TV USING THE VCR'S TUNER

1.  Turn on the TV and set it to the same channel as the VCR's OUTPUT
    CHANNEL switch (3 or 4).

    If you are using a TV/monitor that is connected to the VCR's
    AUDIO/VIDEO OUT jacks, set it to the video mode.

2.  Press TV/VCR until VCR appears on the VCR's display.

3.  Press CHANNEL \/ or /\ on the remote control, or use the remote
    control's number buttons to select the desired channel.

(ALL-01/17/95)