Pocketvision-36 Color TV
(160-0173)                 Connections                Faxback Doc. # 31244

CONNECTING AN EXTERNAL ANTENNA

If you are in an area with weak TV signals, or are inside a metal or
concrete building, you might need an external outdoor antenna to improve
reception.  Connect the antenna to the EXT ANT jack.

If your antenna wire is 75-ohm coaxial cable, use an F-to-mini plug adapter
to complete the connection.  If you have 300-ohm wire, use a 300-to-75 ohm
mini-plug adapter.

USING THE TV AS A MONITOR

You can play back the signal from an audio/video component on your TV using
a special cable (not supplied), available at your local Radio Shack store.

Connect the cable's yellow plug to the component's video output jack and
its white plug to the component's audio output jack.  Then plug the cable's
sub-mini plug into the TV's AUDIO/VIDEO jack.

NOTES:  Do not use standard audio patch cords.  This distorts the audio
        and video signals.

        The TV cannot receive antenna or cable TV signals when an
        audio/video component is connect.

USING YOUR TV

1.  Extend the rod antenna.

2.  Set UHF/VHF/OFF to VHF or UHF.  The TV starts scanning and stops at the
    next active channel in the selected band.

3.  Press TUNING < or > to tune to the next active channel.  The tuning
    line on the screen aligns with the selected channel number above the
    screen.

4.  Adjust VOLUME.

5.  Adjust BRIGHT for the desired brightness.  The brightness also changes
    with the screen's angle.

NOTES:  If desired, fold out the stand on the back of the TV and lean
        the TV on a flat surface at a convenient viewing angle.

        If reception is poor, adjust the length or angle of the rod
        antenna.  If inside a metal or concrete building, moving closer
        to a window might improve reception.

BACKLIGHT

In low temperature, the TV screen takes a few seconds to light, or it
might be slightly red in color.  This is not a malfunction.  Normal
operation resumes after a short while.

USING AN EARPHONE

For private listening, you can connect an option earphone with a 1/8-inch
plug to the EAR jack.  This automatically mutes the built-in speaker.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening.
           Then, adjust the volume to a comfortable level.

           Do not wear the earphone while operating a motor vehicle or
           riding a bicycle.  This can cause a traffic hazard and is 
           illegal in some areas.



(SP/YO 3/13/96)