Archer Color Supreme 200 Antenna
(150-1831)                 Connections                Faxback Doc. # 31404

The antenna system includes a 36-inch coaxial cable.  This cable connects
the antenna to your TV or receiver.  Some TVs FM receivers require twin
lead wire (not supplied).  You can purchase this wire and any necessary
adapters at any Radio Shack store.

NOTE:  If you use the antenna's 75-ohm cable terminal, remove the 75-ohm
       terminator.  If you use the screw terminals, remove the resistors.
       Save the resisters and terminator so you can replace them whenever
       you are not using the corresponding terminal.

If your TV has a single antenna input, connect the cable to the antenna's
terminal and to the TV's antenna terminal.

If your TV has coaxial VHF and twin-lead UHF terminals, use the supplied
cable for the VHF connection, and a twin-lead wire for the UHF connection.

For FM reception, connect either VHF antenna output to your receiver using
the appropriate cable or wire.

For TV's with UHF/VHF screw terminals, use two twin-lead wires.  Connect
the wires to the antenna's UHF and VHF screw terminals and to the TV's
screw terminals.

AC POWER

This antenna uses AC power.

1.  Insert the supplied AC adapter's small plug into the 9VDC jack at the
    back of the antenna.

2.  Plug the adapter into any standard wall outlet.


(SP/yo 3/19/96)