Portavision 4 1/2" Television with Cassette Recorder (160-0128) Operation Faxback Doc. # 8176 USING THE TELEVISION Follow these steps to operate your television. 1. Press POWER ON/OFF to ON. 2. Set VOLUME MIN/MAX to its lowest level. 3. Set TV/RADIO/TAPE FUNCTION to TV. 4. Set VHF Lo/Hi UHF to the desired band For channels 2 through 6, set VHF Lo/Hi UHF to VHF Lo. For channels 7 through 13, set VHF Lo/Hi UHF to VHF Hi. For channels beyond 13, set VHF lo/Hi UHF TO UHF. 5. Rotate Tuning to select the desired station. 6. Adjust VOLUME MIN/MAX to a comfortable listening level. 7. Adjust BRIGHT and CONTRAST until you obtain the best picture. Note: To stop vertical rolling of the TV picture, adjust V-HOLD. 8. Adjust the antenna to get the clearest image. See "Antennas", on Faxback Doc. # 31564. TV Reception Tips * Weak signal reception might cause snow (small white dots) to appear on your TV picture. Too much distance between your TV and the station's transmitter can cause weak reception. Buildings with large amounts of steel construction can cause reception problems as well. Try changing the position and length of the antenna. If this does not help, use an outdoor antenna as described in "Antennas", on Faxback Doc. # 31564. * Snow along with a tear or roll can often be due to improper tuning. * If the image does not fill the screen at the sides, replace the batteries. See "Using Battery Power", on Faxback Doc. # 31564. USING THE RADIO Follow these steps to operate your radio. 1. Press POWER ON/OFF to ON. 2. Set VOLUME MIN/MAX to its lowest setting. 3. Set TV/RADIO/TAPE FUNCTION to RADIO. 4. Set AM/FM to the desired band. 5. Rotate TUNING to select the desired station. 6. Adjust VOLUME MIN/MAX to a comfortable listening level. 7. Extend your system's antenna fully for improved FM reception. Radio Reception Tips * Weak FM reception is generally caused by problems similar to those described in "TV Reception Tips." Use an outdoor antenna to improve your system's reception. * Weak AM reception can be caused by the station's transmitter being too far away, or by operating your system in a building with steel construction. Turn your system in different directions to find the best position for the built-in AM antenna. USING THE CASSETTE DECK Playing a Cassette Before loading a cassette, take up any slack in the tape by turning the tape hub with a pencil or your finger. (Avoid touching the tape.) Caution: If you do not remove excess slack, the tape might become tangled in the record/playback mechanism. 1. Press STOP/EJECT to open the cassette compartment door. 2. Load a cassette with the open end up and the side you want to play facing you. 3. Close the door. 4. Set VOLUME MIN/MAX to its lowest setting. 5. Set TV/RADIO/TAPE FUNCTION to TAPE. 6. Press PLAY Note: Press PAUSE to temporarily stop play. Press PAUSE again to resume play. 7. Adjust VOLUME MIN/MAX to a comfortable listening level. The tape automatically stops when it reaches the end. Fast-Forward and Rewind Press FAST-F to rapidly advance a tape. Press REWIND to quickly rewind a tape. When the tape reaches the desired point, press STOP/EJECT. Caution: To avoid damaging the tape, do not go directly from rewind to fast-forward or from fast-forward to rewind without pressing STOP/EJECT first. NOTE: Auto-stop does not work with fast-forward and rewind. Recording Sound from Radio or TV 1. Set TV/RADIO/TAPE FUNCTION to RADIO or TV. 2. Set AM/FM or VHF Lo/Hi UHF to the desired band. 3. Rotate TUNING to select the desired station. 4. Load a blank cassette (or one you want to record over) into the cassette compartment. 5. Press RECORD. PLAY automatically goes down. Caution: Never attempt to force the RECORD button. If you have removed your cassette's erase-protection tabs, you cannot press RECORD. See "Hints and Tips", on Faxback Doc. # 31565. 6. Press STOP/EJECT to stop recording. PLAY and RECORD pop up and the tape motor automatically stops. Press STOP/EJECT again to remove the cassette. NOTES: You can monitor the signal as the system records it, either through the speaker or headphones. The VOLUME MIN/MAX control does not affect the recording level. To temporarily stop recording, press PAUSE. Press PAUSE again to resume recording. Making Live Recordings Follow these steps to use the built-in microphone to make live recordings. 1. Set TV/RADIO/TAPE FUNCTION to TAPE. 2. Load a blank cassette (or one you want to record over) into the cassette deck 3. Place the system about five feet from the recording source. 4. Press RECORD to begin recording PLAY automatically goes down. 5. Press STOP/EJECT to stop recording. PLAY and RECORD pop up. Note: The tape automatically stops when it reaches the end. USING AN EARPHONE For private listening, you can connect an optional earphone or headphones with a 1/8-inch plug. Your local Radio Shack store sells a wide selection of earphones and headphones to choose from. NOTE: If you connect a pair of stereo headphones, you only hear sound from one side. Insert the earphone/headphones' plug into the HEADPHONE jack. This automatically disconnects the system's internal speaker. Listening Safely To protect your hearing, follow these guidelines when you use an earphone/ headphones. Do not listen at extremely high volume levels. Extended high-volume listening can lead to permanent hearing loss. Set the volume to the lowest level possible before you begin listening. Put on the earphone/headphones, then gradually increase the volume as necessary. Once you set the volume, do not increase it. Over a period of time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing. Traffic Safety Do not wear an earphone while operating a motor vehicle. Even though some earphones are designed to let you hear some outside sounds when listening at normal volume levels, they still present a traffic hazard and are illegal in some areas. (EB/all-04/01/96)