Citizen PROjet II  (260-2957)        Print Test        Faxback Doc. # 14696

As soon as you have unpacked and installed the printer, run the print test
to check that it operates correctly.

The print test contains information on the printer firmware (release,
emulation and character generators).

Running the Print Test

CAUTION:  Make sure that the print head is inserted and that there is
          paper in the paper tray.

          The print test is started from a printer-off condition.

Holding down the LINE FEED key on the operator panel, switch on the
printer.  (Keep the key held down until the mechanical reset has been
completed.)

The print test will be executed automatically.

To suspend the print test temporarily, press the ON LINE key (pressing
this key a second time will cause printing to resume).  To truncate
the print test, switch the printer off.

Once the test is completed and the last sheet of paper expelled, the
printer will go automatically into ON LINE condition.

Check the print quality of the test, making sure that all the characters
are clearly defined  and complete.

CAUTION:  If you have any problems running the print test, check that you
          have followed the operating procedures correctly; if so, see
          Troubleshooting (Faxback Doc. # 14709).

Print Test Contents

The first line of the print test contains information on the printer
status:

    - At the left hand margin: the resident (or selected) emulation

    - Centered: the firmware release (Xnn.nnn).

    - At the right hand margin: the date of issue of the firmware level.

    The second line of print allows you to check whether any dots are
    missing.  If there are, see the section entitled PRIME Operation-
    Maintenance and Troubleshooting - For the possible solutions to this
    problem.  Then repeat the print test.

    The rest of the print test contains a print-out of the resident (or
    optional) fonts in portrait and/or landscape with all their attributes
    (optional fonts will be printed ONLY if a specific memory card is
    inserted and selected.

Once you have checked that your printer prints correctly, connect it to
your personal computer or host system.


(LB/all-04/21/95)