Graffiti Reference Card  (250-3116)    Installation    Faxback Doc. # 14963

Requirements:

A PC- compatible computer is used to install Graffiti onto the PDA.  The
following is required to install Graffiti:

    A PC to PDA serial null-modem cable (PalmConnect cable, Casio SB-82, or 
    Radio Shack #25-3101)

    An IBM, or 100% compatible PC/AT personal computer

    MS-DOS 3.3 or higher

    640K of RAM memory

    A 3.5 inch diskette drive (other diskette sizes are available on
    request)

    One available serial (COM) port

Procedure

Once you have determined that there is sufficient free memory available in
your PDA and have connected the null-modem cable, you are ready to install
the Graffiti software.

If the available memory space is limited, you may choose to omit
Graffiti's Tutorial or Online Help software components.  The Installer
program gives you the flexibility to install any combination of Graffiti
software components.

IMPORTANT:  To prevent the possibility of running out of power during the
            installation, you should install new battereies in your PDA
            before you begin.

To install the Graffiti software onto your PDA:

1.  Boot your PC, and turn on your PDA.

2.  Insert the Graffiti software diskette into a disk drive on your PC.

3.  At the DOS prompt, type a:install (or b:install, depending on the
    location of your disk drive), and then press the Enter key.

4.  In a moment, the Installation start up screen will appear.

5.  Press the Enter key on the keyboard to continue.

6.  Detailed instructions will appear on screen for each step of the
    installation procedure.

7.  When the installation is complete, the Installation start up screen
    will appear, with the Exit option highlighted.  Press the Enter key on
    the keyboard to exit the Installer.

8.  Press either the A or B button on the PDA.  Note that the screen of
    the PDA will remain blank for about a minute as the new software is
    loaded for use.  When the screen on the PDA reappears, Graffiti
    installation is complete.


(TE/all-04/26/95)