Western Digital  (250-0105/6)    32-bit Disk Access    Faxback Doc. # 15667
Hard Disk Upgrade Kits

ENABLING 32-BIT DISK ACCESS IN WINDOWS 3.1X

To enable 32-bit disk access in Windows 3.1x you must run the Western
Digital DMCFIG utility located on the Ontrack Disk Manager diskette. 
Windows must be installed prior to running DMCFIG.

To run DMCFIG:

1.  Insert the Ontrack Disk Manager diskette into drive A (or B).  At the
    A> (or B>) prompt, type:  dmcfig

    You may see the following questions.  If so, answer them as follows:

    Ready to Update Dynamic Drive Overlay?          NO
    Ready to Modify CONFIG.SYS?                     NO
    Ready to Copy WDCDRV.386?                       YES
    Ready to Modify C:\WINDOWS\SYSTEM.INI to
    include enhanced FASTDISK driver?               YES

2.  DMCFIG has completed its installation.  Remove the Ontrack Disk Manager
    diskette and reboot your system.

To Enable 32-bit Disk Access in Windows, follow these steps.

1.  Start Windows.  Select Control Panel, then select 386 Enhanced.

2.  Select Virtual Memory, then select Change.

3.  At the bottom of the screen the option "Use 32-bit Disk Access" is
    preceded by a box.  Move your cursor to the box and select it.  Select
    OK.


(ALL-06/14/95)