WP-2 Portable Word  (260-3930)      Addendum           Faxback Doc. # 16699
Processor

Creating a File to Transfer via Modem or Direct Connect

From within a file, press <F2> <=> to go to the file menu.  Press <F1> <N>
to create a new file.  Type in a paragraph or two.  Press <F2> <=> to go to
the file menu.  Press <ENTER> on MEMORY to get a list of files.  Highlight
the file you just created and type <F1> <A> to convert the document to
ASCII format.  The file will now have a .DA extension instead of .DO.  Do
not go back into this file or the format will be changed back and the
extension will be .DO.

Transferring a file to a PC

A direct connect transfer requires a serial cable, null modem adapter, and
communications software on the PC to receive the file.

From within a file, press <F2> <-> to go into setup.  Highlight Telcom and
press <ENTER>.  Set the parameters as desired and be sure to press <SHIFT>
<DOWN ARROW> to see the second page of settings.  This is where the file
transfer protocol is set.  The two options are ASCII and CRC-XMODEM.  ASCII
sends information in 80 character lines.  XMODEM will keep the format of
document.   Press <F2> <backspace> to exit setup.  This will return you to
your current document.  Press <F2> <9> to enter Telcom.  Setup all
parameters in communications program on PC.   Make sure communications
protocols are the same.  Press the button on the PC to start receiving the
file.  On the WP-2, press <F1> <U> to upload, press <ENTER> for MEMORY, and
type the filename with the .DA extension and <ENTER>.  You should see the
message "UPLOADING..." and get consecutive dots as the transfer proceeds.
When the upload is complete, you can press <F2> <backspace> to go back to
the current document.


(ABO/all-08/24/95)