WP-2 Portable Word Processor
(260-3930)    TRANSFERRING A FILE FROM WP-2 TO A PC   Faxback Doc. # 17527

A direct connect transfer requires a serial cable, null modem adapter, and
communications software on the PC to receive the file.

From within a file, press [F2] to go into setup. Highlight Telcom and press
enter.  Set parameters as desired and be sure to press [SHIFT]+[DOWN ARROW]
to see second page of settings.  This is where the file transfer protocol 
is set.  The two options are ASCII and CRC-XMODEM. ASCII sends information 
in 80 characters per line.  XMODEM will keep the format of the document. 
Press [F2]+[BACKSPACE] to exit setup.  This will return you to your current
document.  Press [F2]+[9] to enter Telcom.  Setup all communications 
parameters in PC.  Make sure communications protocalls are the same.  Press
button on PC to start receiving file.  On WP-2 press [F1]+[U] to upload, 
press enter for MEMORY, type filename with .DA extension and enter.  Should
see "UPLOADING...." and get consecutive dots as transfer proceeds.  When 
upload is complete you can press [F2]+[BACKSPACE] to go back to current
document. 


(DF/tmc-12/01/95)