Graphics Master Board  (250-3044)     Installation      Faxback Doc. # 2077

Unpack Graphics Master and place it component side up on a smooth, flat, 
non-static surface.

Turn your computer system switch to OFF.

Turn all external option power switches to OFF (Printer, TV, etc). and
disconnect all cables.

Unplug you computer system and all other options from the wall outlet.

Assemble the following:

   1 medium size flat-blade screwdriver
   1 pair of tweezers or needle nose pliers
   1 ball point pen

Remove the cover of the System Unit.

You are now ready to install the Graphics Master in your system. Follow 
the step by step instructions below:.

Choose the expansion slot for your Graphics Master. Remove the screw at 
the top of the slot and gently pull the slot cover upward.

Double check the jumper settings by turning back to the diagram for the
setup you have chosen.

Locate the black plastic card edge guide that comes with your Graphics
Master. Snap the card edge guide into the front of the computer opposite
the slot you chose. The "fingers" in the channel on the card edge guide
should be pointing down.

Position the board over the slot so that the gold fingers on the bottom of
the board are directly over the slot connector on the bottom of the unit.

Hold the board by the top corners and press it firmly into the chosen slot.

The black metal option retaining bracket (ORB) on the board should now be
even with the rear panel of the unit, and the hole in the ORB should line
up with the slot cover you removed.

Replace the screw you removed and use it to fasten the board firmly in the
slot.

Replace the cover of your personal computer or Expansion Chassis.

Attach cables to boards, monitors, system unit, and electrical outlets as
appropriate.

Your Graphics Master is now fully installed and ready for use.