DMP-134  (260-2848)            Switch Settings         Faxback Doc. # 4530

SETTING THE PRINT FUNCTION (DIP) SWITCHES

There are six switches located on the printed circuit board inside the
printer.  These switches control various features of your printer.  For 
each switch function, see Table 2, "DIP Switch Print Functions."

                        TABLE 2.  DIP SWITCH FUNCTIONS

      ┌─────┬─────────────────┬───────────────────┬───────────────────┐
      │ SW. │     SYMBOL      │        ON         │        OFF        │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  1  │  FF             │  Ignored          │  Valid            │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  2  │  Zero Style     │  Slashed Zero     │  Unslashed Zero   │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  3  │  CR             │  Carriage Return  │  Carriage Return  │
      │     │                 │  and Line Feed    │  Only (CR = CR)   │
      │     │                 │  (CR = CR + LF)   │                   │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  4  │  Form Length    │  12 inches        │  11 inches        │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  5  │  Character Set  │  Character Set 2  │  Character Set 1  │
      ├─────┼─────────────────┼───────────────────┼───────────────────┤
      │  6  │  LF             │  Line Feed and    │  Line Feed Only   │
      │     │                 │  Carriage Return  │  (LF = LF)        │
      │     │                 │  (LF = LF + CR)   │                   │
      └─────┴─────────────────┴───────────────────┴───────────────────┘

NOTE:  When you set DIP switch 1 to ON, the FF code is ignored at the top 
       of the form position.

Figure 14 shows the default switch settings.  Note that the black square 
represents the switch and the white square represents the empty position.

NOTE:  The printer must be off before you change any of the switches.

If you have been printing, allow the print head to cool down before 
touching it.  When setting the switches, open the printer cover, remove 
the ribbon cassette, and manually move the print head to the right.  
Grasp the fin of the compartment cover on the mechanical frame and slide 
it to the left to remove it.

After setting the DIP switches, replace the compartment cover, reinstall
the ribbon cassette and replace the printer cover.

(dtc-07/26/93)