Super Powerhorn  (400-1307)        Installation       Faxback Doc. # 14010

MOUNTING THE POWERHORN

Before you mount the powerhorn, remove the powerhorn's mounting base so
that you can use it as a template.

1.  Loosen the wingnut and slide off the mounting base.


2.  Secure the mounting base at the desired location. Then, slide the
    speaker section back onto the mounting base.


3.  Adjust the powerhorn's speaker to the desired angle. Then, tighten the
    wingnut.

Cautions:  Be sure that you angle the powerhorn's speaker slightly
           downward to prevent water from collecting inside.

           Mount the powerhorn away from heat sources to prevent 
           damaging the powerhorn's speaker casing.

CONNECTING THE POWERHORN TO AN AMPLIFIER

Your powerhorn is designed for connection to an amplifier with an
impedance of 8 ohms.

1.  Connect the powerhorn's black wire to the amplifier's negative speaker
    terminal.

2.  Connect the powerhorn's white wire to the amplifier's positive speaker
    terminal.

(ALL-03/08/95)