FM Wireless Microphone  (330-1076)       Operation     Faxback Doc. # 15283

TUNING

You'll need to tune your Wireless Microphone to a blank spot within the FM
band.  To do this, use the tuning tool molded onto the tip of the antenna
wire.  First, turn off the AFC and Muting controls if your receiver has
them.  Next, turn your receiver to the extreme top of the dial (108) and
then slowly tune downwards (towards 88).  Stop at the quietest blank spot
after passing the first station.  You will obtain the best results when no
stations can be heard at the blank spot.  When you turn up the volume you
should only hear hissing.  This step is very important and care should be
taken to locate the quietest blank spot.

There is a small hole on the front of your Wireless Microphone case.  With
the battery installed, set the power switch to ON and insert the tuning
tool tip through the hole.  Do not push in.  At the bottom of the hole is a
screw that adjusts the frequency of your Wireless Microphone.  Carefully
turn the screw with the tuning tool tip.  If your receiver has no tuning
indicator, listen for a high pitched whistle (called feedback) from your
receiver.  Slowly adjust the screw until you have the loudest whistle from
your FM receiver.  Now your wireless Microphone and the FM receiver are on
the same frequency.


(ALL-07/20/95)