Wireless Video Microphone  (320-1226)   Preparation    Faxback Doc. # 15503

INSTALLING THE TRANSMITTER'S BATTERY

1.  Slide the transmitter's hinged battery compartment cover in the
    direction of the arrow and swing it open.

2.  Insert the battery into the compartment.

3.  Connect a 9-volt battery to the snap connector.

4.  Close the battery compartment cover.

Note:  The BATTERY LOW indicator lights when the battery is weak.  When
       the indicator lights, be sure to replace the battery.

ATTACHING THE MICROPHONE BELT CLIP

Slide the belt clip onto the block located on the back of the transmitter
until the clip locks into place.

To remove the clip, lift the locking tab and slide the clip off.

INSTALLING THE RECEIVER'S BATTERY

1.  Push the grooved tab on the battery compartment cover in the direction
    of the arrow while lifting the cover upward to remove it.

2.  Insert the battery into the compartment.

3.  Connect a 9-volt battery to the snap connector.

4.  Close the battery compartment cover.

CONNECTING THE RECEIVER

1.  Mount the wireless microphone receiver on the camera or camcorder,
    using the shoe-mount bracket.

2.  Plug the supplied audio cord into the wireless microphone receiver's
    MIC OUT jack.  Plug the other end into the camera or camcorder's
    microphone jack.


(br/all-06/02/95)