Highball Dynamic  (330-0984)      Operation            Faxback Doc. # 16019
Microphone

IMPEDANCE SELECTION

Your Highball Dynamic Mike is set to 600 ohm impedance.  To change to 10K
ohm, follow these steps:

1.  Loosen the connector fitting screw on the grip case end and remove it.

2.  Pull out the connector.  You'll find a socket with a yellow wire
    inserted into the #3 terminal.  Remove this socket.  You'll find
    another socket with a blue lead.  Insert this into the #3 terminal.

3.  Position the socket with the yellow lead in the middle part of the
    connector.

4.  Return the connector to the grip case.  Tighten the fitting screw.


(ALL-07/20/95)